| Abbreviation | IP |
|---|---|
| Purpose | Relay datagrams across network boundaries and route packets |
| Developers | Vint Cerf and Bob Kahn (under DARPA) |
| Introduction | May 1974 (1974-05) |
| Based on | Transmission Control Program |
| Influenced | IPv4, IPv6, IPsec |
| OSI layer | Network layer |
| RFC | 791 |
| Hardware | Routers, Layer 3 switches |
The Internet Protocol (IP) is the network layer communications protocol in the for relaying across network boundaries. Its function enables , and essentially establishes the .
IP has the task of delivering packets from the source host to the destination host solely based on the IP addresses in the packet headers. For this purpose, IP defines packet structures that encapsulate the data to be delivered. It also defines addressing methods that are used to label the datagram with source and destination information.
IP was the connectionless datagram service in the original Transmission Control Program introduced by Vint Cerf and Bob Kahn in 1974, which was complemented by a connection-oriented service that became the basis for the Transmission Control Protocol (TCP). The Internet protocol suite is therefore often referred to as TCP/IP.
The first major version of IP, Internet Protocol version 4 (IPv4), is the dominant protocol of the Internet. Its successor is Internet Protocol version 6 (IPv6), which has been in increasing deployment on the public Internet since around 2006.1
Where Internet Protocol leads. Every connection below has a source: a link in this article, a shared Wikipedia category, or CirrusSearch text similarity. Articles already on your trail are left out.
1,739 words · 32 references · revision 1382802385 · CC BY-SA 4.0
The articles this one links to most, weighted towards the introduction.
The Internet Protocol is responsible for addressing host interfaces, encapsulating data into datagrams (including fragmentation and reassembly) and routing datagrams from a source host interface to a destination host interface across one or more IP networks.2 For these purposes, the Internet Protocol defines the format of packets and provides an addressing system.
Each datagram has two components: a header and a payload. The IP header includes a source IP address, a destination IP address, and other metadata needed to route and deliver the datagram. The payload is the data that is transported. This method of nesting the data payload in a packet with a header is called encapsulation.
IP addressing entails the assignment of IP addresses and associated parameters to host interfaces. The address space is divided into subnets, involving the designation of network prefixes. IP routing is performed by all hosts, as well as routers, whose main function is to transport packets across network boundaries. Routers communicate with one another via specially designed routing protocols, either interior gateway protocols or exterior gateway protocols, as needed for the topology of the network.3
There are four principal addressing methods in the Internet Protocol:
In May 1974, the Institute of Electrical and Electronics Engineers (IEEE) published a paper entitled "A Protocol for Packet Network Intercommunication".5 The paper's authors, Vint Cerf and Bob Kahn, described an internetworking protocol for sharing resources using packet switching among . A central control component of this model was the Transmission Control Program that incorporated both connection-oriented links and datagram services between hosts. The monolithic Transmission Control Program was later divided into a modular architecture consisting of the and at the and the Internet Protocol at the . The model became known as the and , and informally as .
The design of the Internet protocol suite adheres to the end-to-end principle, a concept adapted from the CYCLADES project. Under the end-to-end principle, the network infrastructure is considered inherently unreliable at any single network element or transmission medium and is dynamic in terms of the availability of links and nodes. No central monitoring or performance measurement facility exists that tracks or maintains the state of the network. For the benefit of reducing network complexity, the intelligence in the network is located in the end nodes.
As a consequence of this design, the Internet Protocol only provides best-effort delivery and its service is characterized as unreliable. In network architectural parlance, it is a connectionless protocol, in contrast to connection-oriented communication. Various fault conditions may occur, such as data corruption, packet loss and duplication.25 Because routing is dynamic, meaning every packet is treated independently, and because the network maintains no state based on the path of prior packets, different packets may be routed to the same destination via different paths, resulting in out-of-order delivery to the receiver.
All fault conditions in the network must be detected and compensated for by the participating end nodes. The upper layer protocols of the Internet protocol suite are responsible for resolving reliability issues. For example, a host may network data to ensure correct ordering before the data is delivered to an application.
The dynamic nature of the Internet and the diversity of its components provide no guarantee that any particular path is actually capable of, or suitable for, performing the data transmission requested. One of the technical constraints is the size of data packets possible on a given link. Facilities exist to examine the maximum transmission unit (MTU) size of the local link and Path MTU Discovery can be used for the entire intended path to the destination.27
The IPv4 internetworking layer automatically fragments a datagram into smaller units for transmission when the link MTU is exceeded. IP provides reordering of fragments received out of order.28 An IPv6 network does not perform fragmentation in network elements, but requires end hosts and higher-layer protocols to avoid exceeding the path MTU.29
The Transmission Control Protocol (TCP) is an example of a protocol that adjusts its segment size to be smaller than the MTU. The User Datagram Protocol (UDP) and ICMP disregard MTU size, thereby forcing IP to fragment oversized datagrams.30
During the design phase of the ARPANET and the early Internet, the security aspects and needs of a public, international network were not adequately anticipated. Consequently, many Internet protocols exhibited vulnerabilities highlighted by network attacks and later security assessments. In 2008, a thorough security assessment and proposed mitigation of problems was published.31 The IETF has been pursuing further studies.32
The following Internet Experiment Note (IEN) documents describe the evolution of the Internet Protocol into the modern version of IPv4:6
IP versions 1 to 3 were experimental versions, designed between 1973 and 1978.7 Versions 2 and 3 supported variable-length addresses ranging between 1 and 16 octets (between 8 and 128 bits).8 An early draft of version 4 supported variable-length addresses of up to 256 octets (up to 2048 bits)9 but this was later abandoned in favor of a fixed-size 32-bit address in the final version of IPv4. This remains the dominant internetworking protocol in use in the Internet Layer; the number 4 identifies the protocol version, carried in every IP datagram. IPv4 is defined in RFC 791 (1981).
Version number 5 was used by the Internet Stream Protocol, an experimental streaming protocol that was not adopted.7
The successor to IPv4 is IPv6. IPv6 was a result of several years of experimentation and dialog during which various protocol models were proposed, such as TP/IX (RFC 1475), PIP (RFC 1621) and TUBA (TCP and UDP with Bigger Addresses, RFC 1347). Its most prominent difference from version 4 is the size of the addresses. While IPv4 uses 32 bits for addressing, yielding c. 4.3 billion (4.3×109) addresses, IPv6 uses 128-bit addresses providing c. 3.4×1038 addresses. Although adoption of IPv6 has been slow, as of January 2023, most countries in the world show significant adoption of IPv6,10 with over 41% of Google's traffic being carried over IPv6 connections.11
The assignment of the new protocol as IPv6 was uncertain until due diligence assured that IPv6 had not been used previously.12 Other Internet Layer protocols have been assigned version numbers,13 such as 7 (IP/TX), 8 and 9 (historic). Notably, on April 1, 1994, the IETF published an April Fools' Day RfC about IPv9.14 IPv9 was also used in an alternate proposed address space expansion called TUBA.15 A 2004 Chinese proposal for an IPv9 protocol appears to be unrelated to all of these, and is not endorsed by the IETF.
Main article: List of IP version numbers
As the version number is carried in a four-bit field, only numbers 0–15 can be assigned.
| IP version | Description | Year | Status |
|---|---|---|---|
| 0 | Internet Protocol, pre-v4 | N/A | Reserved16 |
| 1 | Experimental version | 1973 | Obsolete |
| 2 | Experimental version | 1977 | Obsolete |
| 3 | Experimental version | 1978 | Obsolete |
| 4 | Internet Protocol version 4 (IPv4)17 | 1981 | Active |
| 5 | Internet Stream Protocol (ST) | 1979 | Obsolete, superseded by ST-II (or ST2) |
| Internet Stream Protocol (ST-II or ST2) | 1987 | Obsolete, superseded by ST2+ | |
| Internet Stream Protocol (ST2+)18 | 1995 | Obsolete | |
| 6 | Simple Internet Protocol (SIP) | N/A | Obsolete, merged into IPv6 in 199516 |
| Internet Protocol version 6 (IPv6)19 | 1995 | Active | |
| 7 | TP/IX The Next Internet (IPv7)20 | 1993 | Obsolete21 |
| 8 | P Internet Protocol (PIP)22 | 1994 | Obsolete, merged into SIP in 1993 |
| 9 | TCP and UDP over Bigger Addresses (TUBA) | 1992 | Obsolete23 |
| IPv9 | 1994 | April Fools' Day joke24 | |
| Chinese IPv9 | 2004 | Abandoned | |
| 10–14 | N/A | N/A | Unassigned |
| 15 | Version field sentinel value | N/A | Reserved |
IPv4 provides safeguards to ensure that the header of an IP packet is error-free. A routing node discards packets that fail a header checksum test. Although the Internet Control Message Protocol (ICMP) provides notification of errors, a routing node is not required to notify either end node of errors. IPv6, by contrast, operates without header checksums, since current link layer technology is assumed to provide sufficient error detection.2619
2,732 revisions in total · 1,537 contributors · +36 / 0 bytes across 2 edits by 2 contributors in the last 30 days
